Security Camera Pixel Density Calculator

Will your camera show who is at the door, or just a blurry shape? Enter its resolution and lens angle, and see how many pixels land on a face at any distance.

Your camera

Units
px

The first number in the resolution, such as 2560 in 2560 x 1440.

°

From the spec sheet. Use the horizontal figure, not the diagonal one.

ft

From the ground to the lens.

ft

From the wall under the camera to where a person would stand.

Detail on a face there

- px/ft

- pixels per meter, - out

Detail zone-
What that means-
Lens to face, in a straight line-
Detail zones along the ground in front of the camera. The marker is the distance you entered.
How far each detail zone reaches
ZoneNeedsReaches out to

This is an estimate. It only uses the numbers you entered and the assumptions listed below.

What this estimate assumes

  • Detail zones use the IEC 62676-4 (2014) levels: detect at 25, recognize at 125 and identify at 250 pixels per meter (about 7.6, 38 and 76 pixels per foot). The observe level is left out.
  • Pixels are counted at a face 1.6 m (5' 3") up, at the straight-line distance from the lens, in the middle of the picture.
  • Lenses under 180° are worked out as ordinary lenses. Wider lenses are taken to spread their pixels evenly over their angle.
  • It's daytime with good light, and the person faces the camera. Low light, motion blur, video compression and the screen you watch on all lower real detail.

How pixel density works

Pixel density is the camera's pixels across divided by the width of the picture at the person. A 2560 pixel camera with a picture 20 feet wide puts 128 pixels on each foot. Double the distance and the picture doubles in width, so each foot gets half as many pixels.

The IEC 62676-4 standard sets the pixel levels in the table above. Camera makers quote the same levels on spec sheets, so you can compare this tool with theirs. Axis explains the levels and notes that more pixels give a safety margin for bad light and people who look away.

Why camera height matters

A camera mounted high is farther from a face than the ground distance suggests. A lens 10 feet up sits 4.75 feet above a face, so a person standing 4 feet out is really about 6.2 feet away. That's why the tool counts the straight line from the lens to the face.

The same math explains doorbells. Their lens sits close to face height, so the straight line to a visitor is almost the same as the ground distance.

To see how wide the picture is at the same spot, use the security camera field of view calculator. The security camera night vision range calculator shows which zones are left after dark, and the motion sensor coverage area calculator covers sensors. Browse them all on our smart home planning tools page.