Motion Sensor Coverage Area Calculator

A motion sensor box says something like 30 feet and 90°, but what does that cover? Enter the range and angle from the spec sheet and see the floor area, the width and a drawing to scale.

Your sensor

Units
ft

The distance on the spec sheet. For a ceiling sensor, use half the listed diameter.

°

From the spec sheet. A ceiling sensor that sees all the way around is 360°.

ft

Any distance out from the sensor.

What the pattern covers

-

of floor inside the detection pattern (-)

Widest point-
Width - out-
Length of the far edge-
Top-down drawing, to scale. Rings mark each quarter of the range, and the dark line is the width you asked about.

This is an estimate. It only uses the numbers you entered and the assumptions listed below.

What this estimate assumes

  • The pattern is a solid fan with no gaps. Real sensors see through a set of beams with small gaps between them.
  • The range is the maker's figure, measured at the mounting height and conditions in their manual. A different height changes the real range.
  • A person walks across the beams, which is when a sensor reacts fastest.
  • Nothing is in the way. Walls, furniture and glass block a passive infrared sensor, because it senses body heat and glass stops it.
  • This is for motion sensors only. Smoke alarms, CO alarms and other life-safety devices follow the maker's instructions and your local codes, not this tool.

How the coverage area is worked out

A motion sensor sees in a fan shape, like a slice of pie. Its area is the slice's share of a full circle: angle ÷ 360 × π × range². This is the standard area of a sector.

So a 30 foot, 90° sensor covers about 707 square feet. The same sensor at 120° covers about 942 square feet. Range counts the most, since doubling it gives four times the area.

Why real coverage is smaller

Most home sensors are passive infrared. They watch for body heat moving between beams, so movement across the beams is caught fastest. CP Electronics explains that walking straight toward a sensor crosses fewer beams, so it triggers later.

A walk test from the maker's manual shows the real pattern in your room. Use it to check the drawing against what the sensor actually does.

Plan cameras the same way

Cameras follow similar geometry. The security camera field of view calculator shows how wide the picture is, and the security camera pixel density calculator shows how much detail lands on a face. For after dark, use the security camera night vision range calculator. See them all on our smart home planning tools page.