Security Camera Field of View Calculator

Before you drill any holes, find out how much your camera will really show. Enter the lens angle from the spec sheet, and see how wide and tall the picture is at the spot you care about.

Your camera

Units
°

From the spec sheet. Use the horizontal figure, not the diagonal one, which is always bigger.

°

Optional. Leave it blank if the spec sheet doesn't list it.

ft

From the ground to the lens.

ft

From the wall under the camera to the spot you want to check.

Work out the angle from the lens
mm
mm

Use the maker's width in mm if it's listed. Sensor sizes like 1/2.7 inch are names, not real measurements.

This lens gives a horizontal angle of -.

What the camera covers

-

wide, - out, at the height of a face (5' 3" up)

Picture height there-
Lens to face, in a straight line-
Lens worked out as-
Top-down drawing, to scale, out to the distance you entered.
Picture width at other distances
Out along the groundPicture width

This is an estimate. It only uses the numbers you entered and the assumptions listed below.

What this estimate assumes

  • The width is measured where a person's face would be, 1.6 m (5' 3") up, at the straight-line distance from the lens.
  • Lenses under 180° are worked out as ordinary lenses. Wider lenses spread their view evenly, so the width is the curved arc. Very wide lenses often bend the picture like a fisheye, so their real width at the edges can differ.
  • The camera points straight out. Tilting it down changes where the picture lands, and walls, fences and plants can block part of it.
  • The angle comes from the spec sheet or from the focal length and sensor width you entered. Cameras that crop the sensor for video show a narrower view.

How the width is worked out

An ordinary lens sees in a wedge. The width at any distance is 2 × distance × tan(half the lens angle), the standard angle of view formula. A 90° lens shows a picture twice as wide as the distance, so 20 feet out it is 40 feet wide.

If you only know the focal length, the angle comes from the sensor: 2 × atan(sensor width ÷ (2 × focal length)). A shorter focal length gives a wider angle. A 2.8 mm lens on a 1/2.7" sensor works out to about 88°.

A wider view spreads the same pixels

A wide picture is not the same as a sharp one. The camera has a fixed number of pixels across, so the wider the view, the fewer pixels land on each person. To check if a face will have enough detail, try the security camera pixel density calculator.

At night the view often ends sooner than the lens allows, and the security camera night vision range calculator shows where. For sensors, the motion sensor coverage area calculator turns a range and angle into floor area. You'll find every tool on our smart home planning tools page.